65,17 inc. VAT

FIBARO Switch 2 is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. FIBARO Switch 2 allows to control connected devices either via the Z-Wave+ network or via a switch connected directly to it and is equipped with active power and energy consumption metering functionality. FIBARO Switch 2 comes in two versions: Single Switch 2 (FGS-213) – can control one electric device Double Switch 2 (FGS-223) – can control two electic devices

  • Consumption and power measurement attached devices
  • Build in RGB Diode to ranges testing, Calibrating and include
  • Notifications for protection against voltage drop, overheating and overcharging
  • Z-Wave CQ10-500 chip series
  • ‘Easy Szene activate information about the “Relay Switch Module

Condition: new. When shipped to GB or ROI, all our electronic articles come with a BSI-proven power adaptor fitted by our company. For free! (As long the device comes with a power cable.)

 

FIBARO Switch 2 has been designed to turn on / off electrical devices. Thanks to its small size, it can be installed in installation boxes or device housings. Switch 2 allows you to control two devices via the Z-Wave network or using connected buttons. Measuring active power and energy consumption allows you to monitor and reduce electricity bills.

Supports 2 circuits each with a maximum power of 1.5 kW)
Controlled by devices of the FIBARO system or any Z-Wave controller
Microprocessor control
Executive elements: relays
The device works with monostable and bistable buttons
It has an energy measurement

Technical data:

Supply voltage 100 – 240 V AC 50 / 60Hz
Maximum load current: 6A per channel (max 10A in total) IEC
Radio signal power: up to 1mW
Working temperature: 0-35 ° C
Mounting in boxes: Ø ≥ 50mm, depth ≥ 60mm
Compliance with EU directives: EMC 2014/30 / EU; RED 2014/53 / EU; RoHS 2011/65 / EU; LVD 2014/35 / EU
Radio protocol: Z-Wave + (series 500),
Radio frequency: 868.4 MHz EU;
Range: up to 50m outdoors, up to 40m indoors (depending on building materials),
Dimensions (L x W x H): 42.5 x 38.25 x 20.3 mm

Attention:
Unlike in the previous version of the module, the output of the controlled relays is only on 230V. If we want to control a lower voltage, we need to use the FGS-222 module version, which has a potential-free output.

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.